Subaru 86012AG10A Horn Assembly (L)

You can Select Your Vehicle to check if 86012AG10A fits your vehicle.

For 2004 and earlier models, the horns are positioned in front of the radiator and, if applicable, the air conditioning condenser, typically mounted on small brackets bolted to the vertical support. To detach a horn, remove the mounting bracket bolt, then disconnect the electrical connector by depressing the release tab and pulling it off. After removing the bracket bolt, detach the horn from its mounting bracket. Reinstallation follows the reverse order of removal. Begin by disconnecting the cable from the negative terminal of the battery. Next, loosen the right side front wheel lug nuts, block the rear wheels, raise the front of the vehicle, and securely support it on jack stands before removing the right front wheel. Remove the front part of the wheel housing mud guard and splash shield, then pull the shield back. Disconnect the electrical connectors to the horns, remove the horn bracket mounting nut, and take out the horn. Reinstallation is again the reverse of removal.

There was a time when horns were positioned right in front of the radiator and some of them also went with air conditioning condensers. Mounting brackets on which these little things are fixed are usually found on vertical support in the front of radiators as well as conditioners. Reminder: The high tone horn is mounted at the bottom of the radiator support while the low tone horn is mounted under the passenger's side headlamp housing. By removing bumper cover for 2006 and later models, it will allow an individual to replace any one horn. For either horn, release its tab thereby disconnecting electrical connector, then remove bracket bolt. It follows that disengage its mooring from this mounting bracket before pulling them out. Reattach your new item to original place by doing exactly opposite steps taken during removal.