Subaru 42072SA000 Fuel Pump Filter

You can Select Your Vehicle to check if 42072SA000 fits your vehicle.

This procedure applies to all pre-2004 non-turbocharged models with an external fuel filler in the engine compartment. These vehicles have another filter too, which is part of the fuel pump and fuel level sending unit assembly. The external fuel filler in the engine compartment should be replaced at regular intervals prescribed by the manufacturer. No specified maintenance interval for the in-tank fillers on these models but it is advisable to inspect, clean or replace them whenever the fuel pump/fuel level sending unit is removed. On other models, there is no external fuel filler in the engine compartment; instead they rely on filters that are part of their fuel pumps/level sender units. The specified maintenance interval for these models is also 30,000 miles or 30 months, whichever comes first.When changing the fuel filter, start with a cold-engine and place rags/newspapers under it to catch any spilt petrol. Brake master cylinder left hand side of engine compartment where you will find your fuel filter located . Loosen clamps and slide hoses past fittings on filter-Twist carefully pull hose off each end of filter. It's better to change worn out or damaged hoses with new ones If hoses are damaged or deteriorated they should be replaced with new ones Unclip filter bracket from vehicle frame then take out old one and put in a new one Reconnect hoses and reposition clamps tightening them securely Make sure that the fitting marked IN connects to this hose Start car up then check filter hose connections keenly for leaks.

After removing the old filter, unclip the filter bracket, pull the filter out of the bracket, and install the new one. Then, hook up the hoses and reposition the clamps, tightening them securely.

By disconnecting the electrical connector from the fuel pump, removing the pump from the pump holder, and disconnecting the inlet strainer tube from the pump.