Subaru 26257AA061 Brake Shoe-Trailing,Right

You can Select Your Vehicle to check if 26257AA061 fits your vehicle.

Pull off the brake drums, and if they are difficult to remove, use a brake adjuster tool through the access hole to retract the shoes. Clean the brake assembly with brake system cleaner, but avoid using compressed air.

To replace the parking brake shoes, utilize a hold-down spring tool (or screwdriver if applicable), disconnect hold-down cups and springs, unhook the secondary shoe return spring, remove the strut, strut spring, and lower return spring, detach the parking brake cable from the lever, clean the backing plate, lubricate the brake shoe contact areas with high-temperature grease, transfer the parking brake lever to the new secondary shoe, install the hold-down pin, spring, and cup, and lock down the spring. Proceed to install the strut and strut spring, hook the lower return spring to each shoe, install the adjuster between them, place the primary shoe and shoe guide plate, install the hold-down pin, spring, and retainer, and hook the upper return springs to each shoe. Repeat this procedure for the other parking brake assembly.

Engage the slots in the brake shoes with the ends of the adjuster. Attach the upper return spring to both shoes to hold them in place. Position the shoes and adjuster on the brake backing plate and engage the upper ends of the shoes, one at a time, with the slots on the ends of the wheel cylinder pistons. Attach the lower return spring to the leading and trailing shoes. Install the hold-down pins, springs, and cups.

Wash the parking brake assemblies with brake system cleaner.